DMT Presenter Control Guia do Utilizador descarregar pdf (Página 25)

S1 User Handbook

USER GUIDE

TRIM Control

The Trim control is used to tweak the level of the channel on the PGM

output. It provides an additional ±12dB of gain to ne tune the input

signal level. It is a good idea to set up all your audio channels so that

they are all at the same reference level when the fader is fully up,

meaning the mix levels are determined solely by the position of the

faders. This is where to use the trim pots, for level adjustment which

remains constant through the mix.

PAN Control

The Pan control is used to pan the mono input signal on channels 1,2

and 5 in the stereo image. Fully anti-clockwise pans the signal to the

left and increases the signal by 3dB (right channel reduces by 70dB);

full clockwise pans the signal to the right and increases the signal by

3dB (left channel reduces by 70dB).

Balance Control

The balance control is used to alter the stereo image of a stereo input

source on channels 3, 4, 6, 7, 8, 9 and 10. Turning the potentiometer

fully anti-clockwise shifts the signal to the left and increases the signal

by 6dB (right channel reduces by 6dB); fully clockwise shifts the signal

to the right and increases the signal by 6dB (left channel reduces

by 6dB).

CUE/PFL Selection

Selecting the CUE/PFL button routes the pre-fader input signal to the

monitoring system where the signal can be heard via headphones

and/or loudspeakers. The level may be checked on meters and

adjusted via the TRIM control and panned via the PAN control. The

button is illuminated in green when CUE/PFL is active. There is a

conguration option to cancel the CUE/PFL selection when the fader

is raised. This button works with both a momentary and latched

operation. If held down, the selection is cancelled when released,

otherwise the button is alternate action.

CUE/PFL & T/B Selection

On channels 5 and 6 the CUE/PFL and T/B button operates similarly

to a standard CUE/PFL button except the talkback source is also routed

to the respective cleanfeed output when the channel input is set to

Input 2 (5. Telco or 6. Stereo Cleanfeed).

Fig 2-16: TRIM

Control

Fig 2-17: PAN Control

Fig 2-18: Balance

Control

Fig 2-19: CUE/PFL

Selection

Fig 2-20: CUE/PFL &

T/B Selection

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 79 80

Comentários a estes Manuais

Sem comentários

DMT Presenter Control Guia do Utilizador Página 25

Comentários a estes Manuais

Manuais e produtos relacionados com Projetores DMT Presenter Control