DMT Presenter Control Manual do Utilizador descarregar pdf (Página 39)

Chapter 4 - DMT 202CM Control Program

4.1 Control of Temperature and Light Intensity

In addition to the VediView

™

data acquisition and analysis software a program is

installed on the computer allowing temperature and light intensity control of the

Culture Myograph 202CM system.

To run the DMT 202CM control program, please select the “202CM controller” which

was copied to your desktop during installation. “202CM controller” can also be found

in START->All Programs->DMT->202CM

Note:

Make sure that the heat controller is turned on and the microscope is connected to

the frame grabber, before running the 202controller.

4.1.1 Connecting the Heat Controller and the Microscope

When the 202CM Controller is started it will automatically connect to the Microscope

and Heat Controller. In the About Tab, the status of the COM connections is shown. If

the connection fails please check that the Microscope and Heat Controller is turned

on, and that the USB cables is connected.

User Manual vers. 1.4 Chapter 4

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 65 66

Sem comentários

DMT Presenter Control Manual do Utilizador Página 39